Extrude from face, edge, line and sketch in Unigraphics NX 6

to start the extrude in NX 6 there are many options, you can use the extrude command from the sketch, line, edge, and face, various extrude option makes it easy for you to make part

Extrude from Sketch
Click Insert -> Sketch

Select Plane, XY, YZ or XZ, or you can choose face from objects that already exist
Draw your sketch, begin your sketch from line, or polyline, circle,etc. after your sketch was completed, finish your sketch (see picture below)

 

 then click icon extrude then on filter option select connected curves,

then : select your curve, then enter the Z value, click OK to finish it,

Extrude from Line
Make your line, or from exiting line, click extrude icon, on filter selection. Select single curves, then select your line

 

 on the dialog box like below, setting  your limit value, and offset setting, click OK, if finished

Extrude Face

Click extrude icon,on curve rule select face edge, then select the face of your part, Drag the arrow or enter the extrude value, clik OK to finished

Posted in: extrude,extrude line